This item fills the void of a factory safety on a Marlin 1894, 1895 or 336 lever action rifle if a person decides to remove their rifle's cross bolt safety. This piece fits all Marlin centerfire lever-action rifles. It does not fit the Marlin 39A .22 caliber rifles.
This item adds a functional saddle ring to the left side of the receiver on a Marlin lever action. The right side of the receiver where the piece is installed will appear as a mock slot head screw. If installed correctly, the ring can be used to secure the rifle into a scabbard or as a single point sling attachment point. Please read the detailed installation instructions in our "Blog" section which are also linked below.
This part comes with a 5/64" allan wrench for installation and an 8-32 x 3/16" set screw.
Installation Instructions HERE
Please select BLUED or STAINLESS finish from the drop down menu. If you wish to purchase the BLUED version, please choose either "Up & Down" or "Front & Back" saddle ring orientation. All stainless rings are orientated up & down.
Determining whether or not disabling the factory cross-bolt safety is appropriate is the responsibility of the firearm's owner or user. By purchasing this product and installing it you are assuming all responsibility and consequences that may result from altering the factory cross-bolt safety that comes with the firearm. Disabling the factory cross-bolt safety can result in an increased possibility of accidental discharge that could result in injury or worse. Additional caution and special attention should be used when using a firearm with a disabled cross-bolt safety. Always treat a firearm as if it could discharge at any moment to avoid accidents.